Given a Scenario, Troubleshoot Issues with vSphere Distributed Switches (VDS) VCP-VCF-SUPPORT Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   An administrator is verifying the MTU setting on a vSphere Distributed Switch. What is the typical MTU value that should be configured to support jumbo frames?

   • A1500
   • B9216
   • C9000
   • D4096
   Reveal Solution Discussion Select an answer first
2. 2expert · hard

   An administrator is migrating a host from a standard vSwitch to a VDS. After the migration, the host's management network is unreachable. The VDS was created with a management dvPort group, and the host's VMkernel adapter was migrated to it. The physical switch port connected to the host's uplink is configured as a trunk port. What is the most likely cause of the management network loss?

   • AThe VDS is not compatible with the host's version of ESXi.
   • BThe host's VMkernel adapter was not migrated to the VDS.
   • CThe physical switch port is configured as an access port.
   • DThe management dvPort group has a different VLAN ID than the physical switch trunk port allows.
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   Which symptom is most indicative of a bandwidth bottleneck on a vSphere Distributed Switch?

   • AHigh CPU usage on the ESXi host
   • BVMware Tools not responding
   • CIncreased packet loss during peak traffic
   • DStorage latency on the datastore
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   Which component should be examined to determine if a host's physical NIC is properly connected to the VDS?

   • AVMkernel adapter
   • BDistributed port
   • CdvPort group
   • DUplink
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   A vSphere administrator is investigating a reported connectivity issue on a VDS. The VDS health check shows that the VLAN configuration is 'Inconsistent' between two hosts. What does this health check result indicate?

   • AThe physical switch ports connected to the hosts have different VLAN configurations.
   • BThe VDS uplinks are not connected to the physical switch.
   • CThe VDS MTU is set to a different value on the two hosts.
   • DThe VDS teaming policy is misconfigured.
   Reveal Solution Discussion Select an answer first