Given a Scenario, Troubleshoot Issues with vSphere Cluster Configurations VCP-VCF-SUPPORT Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   A DRS cluster has a VM-VM anti-affinity rule that separates two virtual machines. During a maintenance operation, an administrator attempts to place both VMs on the same host. What is the expected DRS behavior?

   • ADRS will ignore the rule because the cluster is in Fully Automated mode.
   • BDRS will automatically migrate one of the VMs to another host to satisfy the rule.
   • CDRS will allow the placement but generate a warning.
   • DDRS will not allow the placement and will report an error.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   An administrator is troubleshooting a vSphere cluster alarm that is not triggering as expected. The alarm is set to trigger when CPU usage exceeds 80% for 5 minutes. The alarm never fires, even though CPU usage is consistently above 80%. What is the most likely cause?

   • AThe alarm is disabled or the trigger is not configured correctly.
   • BThe alarm is configured to monitor a different metric, such as memory usage.
   • CThe alarm's condition is set to 'is above' instead of 'is below'.
   • DThe alarm's action is set to 'Send a notification' but the notification is not configured.
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   A vSAN cluster has 5 hosts, each with one disk group. After a network partition, the cluster reports a 'vSAN partition' alarm. The administrator notices that some VMs are running on hosts in one partition, and other VMs are running on hosts in the other partition. What is the immediate risk?

   • AVMs will be automatically migrated to the other partition.
   • BData loss due to split-brain scenario.
   • CThe cluster will automatically heal the partition by rebalancing data.
   • DPerformance degradation because of reduced disk group capacity.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   A vSphere cluster uses jumbo frames (MTU 9000) for vMotion traffic. An administrator notices that vMotion migrations are failing. What is the most likely cause?

   • AThe vMotion traffic is not encrypted.
   • BThe physical switches are configured with an MTU of 1500.
   • CThe vMotion network is configured on a standard switch instead of a distributed switch.
   • DThe vMotion network is using a different VLAN than the management network.
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   A vSAN cluster is experiencing performance issues. The administrator suspects a network partition between hosts. What is the most likely symptom of a vSAN network partition?

   • AThe vSAN cluster reports a warning about disk group capacity.
   • BSome virtual machines become inaccessible or read-only.
   • CThe vSAN health check shows no issues.
   • DAll virtual machines continue to run normally but with increased latency.
   Reveal Solution Discussion Select an answer first