A static route configured on a Tier-1 Gateway is not being used for traffic to a specific subnet. What is a common cause for this?

The next-hop IP address is not reachable from the Tier-1 Gateway

The static route has a higher administrative distance than a dynamic route

The Tier-1 Gateway is not connected to a Tier-0 Gateway

The static route is configured on the wrong segment

A VCF administrator notices that a route learned via BGP from a physical router is not present in the Tier-0 Gateway's routing table. What is the most likely first step to diagnose this issue?

Reboot the Edge Node hosting the Tier-0 Gateway

Check the MTU settings on the overlay segment

Check the BGP neighbor state to ensure the session is established

Verify the route is advertised from the Tier-0 Gateway to the physical router

In OSPF, what does the 'Full' neighbor state indicate?

The OSPF neighbor relationship is fully established and databases are synchronized

The OSPF neighbor is exchanging hello packets but not routing information

The OSPF neighbor is in a passive state and not participating in routing

The OSPF neighbor has been configured but is not receiving hello packets

VMwareVCP-VCF Support (2V0-15.25)

Domain 8Objective 3

Given a Scenario, Troubleshoot Issues with NSX Routing VCP-VCF-SUPPORT Practice Questions (Page 2)

Part of the Troubleshooting a VCF Fleet - Networking domain, which makes up ~14% of our current practice bank.

13questions here

3free pages

6concepts

Questions 6–10

6foundation · easy
Which NSX-T log file is most likely to contain information about routing protocol events, such as BGP neighbor state changes?
Select an answer first
7foundation · easy
A static route configured on a Tier-1 Gateway is not being used for traffic to a specific subnet. What is a common cause for this?
Select an answer first
8foundation · easy
A VCF administrator notices that a route learned via BGP from a physical router is not present in the Tier-0 Gateway's routing table. What is the most likely first step to diagnose this issue?
Select an answer first
9foundation · easy
Which tool is most appropriate for verifying end-to-end connectivity between two VMs on different segments in an NSX-T environment?
Select an answer first
10foundation · easy
In OSPF, what does the 'Full' neighbor state indicate?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to VCP-VCF-SUPPORT

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by VMware. “VCP-VCF-SUPPORT” is a trademark of its owner, used for identification only.

Given a Scenario, Troubleshoot Issues with NSX Routing VCP-VCF-SUPPORT Practice Questions (Page 2)

Questions 6–10

Which NSX-T log file is most likely to contain information about routing protocol events, such as BGP neighbor state changes?

A static route configured on a Tier-1 Gateway is not being used for traffic to a specific subnet. What is a common cause for this?

A VCF administrator notices that a route learned via BGP from a physical router is not present in the Tier-0 Gateway's routing table. What is the most likely first step to diagnose this issue?

Which tool is most appropriate for verifying end-to-end connectivity between two VMs on different segments in an NSX-T environment?

In OSPF, what does the 'Full' neighbor state indicate?

Keep studying — Troubleshooting a VCF Fleet - Networking