Given a Scenario, Troubleshoot Issues When Scaling a VCF Workload Domain by Adding / Removing Workload Domain Clusters VCP-VCF-SUPPORT Practice Questions (Page 2)

Questions 6–10

1. 6expert · hard

   An administrator is removing a cluster from a Workload Domain. The task fails during the 'Remove Cluster' phase, and the VCF UI shows that the operation has been rolled back. However, the administrator notices that the cluster is still visible in the vCenter Server inventory. What should the administrator do to restore the environment to a stable state?

   • ARe-run the failed operation without any changes.
   • BReboot the vCenter Server to clear the stale inventory entries.
   • CManually remove the cluster from the vCenter Server inventory and retry the removal operation.
   • DContact VMware support to manually clean up the vCenter Server database.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   Which component must be available and healthy in the VCF environment before a new cluster can be added to an existing Workload Domain?

   • AAn NSX-T Edge cluster with at least three nodes
   • BA vCenter Server instance dedicated to the new cluster
   • CA vSAN witness appliance in the same region
   • DA healthy SDDC Manager with sufficient inventory capacity
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   An administrator is removing a cluster from a Workload Domain. The pre-validation checks pass, but the task fails during the 'Remove Cluster' phase with an error stating that the cluster still has vSAN data. The administrator has confirmed that all VMs have been migrated off the cluster. What is the most likely cause of this failure?

   • AThe vSAN cluster is not in a healthy state.
   • BThe vSAN cluster has a storage policy that requires more replicas than the remaining hosts can support.
   • CThe vSAN cluster contains snapshots or other orphaned data that is not associated with any VM.
   • DThe vSAN cluster is still in maintenance mode.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   During cluster removal, the vCenter Server fails to remove the cluster from its inventory. What is the most likely cause?

   • AThe cluster is still registered with NSX-T
   • BThe vCenter Server's database is full
   • CThe vCenter Server's time is out of sync
   • DThe vCenter Server's license has expired
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   When adding a cluster, the operation fails with a 'license not available' error. What is the most likely cause?

   • AThe NSX-T license has expired
   • BThe vCenter Server's license does not support the new cluster
   • CThe SDDC Manager license is invalid
   • DThe vSAN license is not applied to the new cluster
   Reveal Solution Discussion Select an answer first