2.4 Explain Dynamic and Static Routing Protocol Tuning SD-WAN-ENGINEER Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   An SD-WAN engineer notices that traffic to a remote site is not being routed correctly. What is the first step in troubleshooting this routing issue?

   • AReboot the SD-WAN device to clear any routing issues
   • BCheck the physical cable connections to the router
   • CVerify the routing table on the SD-WAN device to see if the expected route is present
   • DImmediately reconfigure all static routes to use a different next hop
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   What is the purpose of route redistribution in an SD-WAN environment?

   • ATo remove all routes from the routing table to reduce overhead
   • BTo change the administrative distance of a route
   • CTo encrypt routing updates between SD-WAN sites
   • DTo inject routes learned from one routing source (e.g., static or OSPF) into another routing protocol
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   What is the role of route preference (administrative distance) when configuring static routes in SD-WAN?

   • AIt sets the speed of the link for the static route
   • BIt defines the encryption algorithm used for the route
   • CIt determines which route is preferred when multiple routes to the same destination exist
   • DIt controls the order in which routes are advertised to other routers
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   In the context of routing protocol tuning, what does the metric of a route represent?

   • AThe administrative preference of the route over other routes from different protocols
   • BThe security level of the route
   • CThe version number of the routing protocol
   • DThe cost or distance associated with a route, used to compare paths to the same destination
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   What is the primary purpose of a dynamic routing protocol in an SD-WAN environment?

   • ATo provide a secure tunnel for encrypting data between SD-WAN sites
   • BTo manually configure each route on every router in the network
   • CTo automatically exchange routing information and adapt to network topology changes without manual intervention
   • DTo replace the need for any routing table on the SD-WAN device
   Reveal Solution Discussion Select an answer first