1.1 Configure Interface NEXT-GENERATION-FIREWALL-ENGINEER Practice Questions (Page 3)

Questions 11–13

1. 11application · medium

   A company is upgrading its network and wants to connect a new server to a Palo Alto Networks firewall using two physical links for redundancy and increased bandwidth. The server is connected to interface 1/1 and 1/2 on the firewall. The administrator wants to configure the firewall to treat these two links as a single logical link. Which configuration should be used?

   • ACreate an Aggregate Ethernet (AE) interface and add interface 1/1 and 1/2 as members.
   • BConfigure interface 1/1 and 1/2 as Layer 2 interfaces and assign them to the same VLAN.
   • CUse a virtual wire between interface 1/1 and 1/2 to pass traffic transparently.
   • DConfigure interface 1/1 and 1/2 as separate Layer 3 interfaces and use policy-based routing to load-balance traffic.
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   Which configuration step is required when setting up an Aggregate Ethernet interface?

   • AAssign physical interfaces to the AE group
   • BAssign a tunnel IP address
   • CCreate a virtual wire between the AE and a physical interface
   • DEnable DHCP on the AE interface
   Reveal Solution Discussion Select an answer first
3. 13foundation · easy

   A network engineer needs to configure a firewall interface to operate as a Layer 2 switch port, forwarding traffic based on MAC addresses and participating in VLANs. Which interface type should be selected?

   • AVirtual wire
   • BTunnel
   • CLayer 3
   • DLayer 2
   Reveal Solution Discussion Select an answer first