1.1 Configure Interface NEXT-GENERATION-FIREWALL-ENGINEER Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What is the purpose of the management interface on a Palo Alto Networks firewall?

   • ATo terminate VPN tunnels
   • BTo route production traffic between networks
   • CTo aggregate multiple physical links
   • DTo provide out-of-band management access
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   When configuring the management interface, which of the following is typically set to control administrative access?

   • AVLAN membership
   • BAllowed IP addresses or services
   • CVirtual wire configuration
   • DAggregate group membership
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which interface type is used to terminate VPN tunnels and requires an IP address for the tunnel endpoint?

   • ATunnel
   • BVirtual wire
   • CLayer 2
   • DAggregate Ethernet
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   What is a key characteristic of a virtual wire interface on a Palo Alto Networks firewall?

   • AIt supports dynamic routing protocols
   • BIt forwards traffic without performing routing
   • CIt requires an IP address for each side
   • DIt must be assigned to a VLAN
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   When configuring a Layer 2 interface on a Palo Alto Networks firewall, what additional configuration is required to allow traffic from multiple broadcast domains to be separated?

   • AAssign an IP address to the interface
   • BCreate a virtual wire between two interfaces
   • CAdd the interface to a VLAN
   • DEnable DHCP client on the interface
   Reveal Solution Discussion Select an answer first