Installation or Expansion of an ONTAP Cluster CERTIFIED-STORAGE-INSTALLATION-ENGINEER-ONTAP Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   According to NetApp hardware installation guidelines, what is the correct way to cable storage shelves to nodes in a cluster?

   • AConnect each shelf directly to a node's management port
   • BConnect each shelf to the node's SAS ports using the recommended cabling topology
   • CUse Ethernet cables to connect shelves to the cluster network switches
   • DConnect shelves in a daisy-chain without regard to path redundancy
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   Which ONTAP command is used to add disks from a newly attached shelf to an existing aggregate?

   • Astorage disk assign
   • Bstorage aggregate add-disks
   • Csystem node add
   • Dvolume create
   Reveal Solution Discussion Select an answer first
4. 13expert · hard

   A company is installing a new ONTAP cluster in a remote data center. The admin has limited remote access and needs to minimize the number of visits. The admin wants to ensure that the cluster setup can be completed remotely without physical intervention. What should the admin do before leaving the data center?

   • AVerify that all nodes and shelves are properly cabled and powered on, and that the console access is available remotely.
   • BInitialize the nodes and create the cluster before leaving, so only configuration remains.
   • CInstall all storage shelves and create aggregates before leaving.
   • DConfigure all network interfaces before leaving, so the cluster is ready for data traffic.
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   What is the purpose of a cluster management LIF in ONTAP?

   • ATo provide a single IP address for managing the entire cluster
   • BTo connect storage shelves to the cluster
   • CTo provide a backup path for cluster interconnect
   • DTo route data traffic between nodes
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   Which tool provides a graphical interface for initializing nodes and creating an ONTAP cluster?

   • ASystem Manager
   • BActive IQ
   • CNetApp Deployment Engine
   • DONTAP CLI only
   Reveal Solution Discussion Select an answer first