After physically installing a new drive shelf, what is the next step in the installation process?

Create volumes on the shelf immediately

Format the shelf's drives with a file system

Verify that the shelf is recognized by the controllers

Assign the shelf a new IP address

A company has added a new drive shelf to an E-Series system. The administrator needs to create a new volume for a critical application that requires high availability and performance. The application will be accessed by two hosts. What should the administrator do?

Create a RAID 0 group and map the volume to both hosts.

Create a RAID 6 group and map the volume to both hosts, but only after formatting the drives.

Create a RAID 5 group and map the volume to only one host.

Create a RAID 10 group and map the volume to both hosts.

An administrator has installed a new drive shelf and connected it to the E-Series controllers. The shelf is powered on, but the SANtricity System Manager shows the shelf as 'unmanaged'. What should the administrator do to make the shelf manageable?

Replace the SAS cables with longer ones to improve signal quality.

Update the shelf's firmware via the SANtricity System Manager.

Reboot the controllers to force the shelf to be recognized.

Assign a unique base ID to the shelf using the switches on the IOMs.

During the physical installation of a new drive shelf, what is the correct procedure for connecting the shelf to the E-Series system?

Connect the shelf to a network switch for management, then power on

Connect both IOMs to the controllers, then power on the shelf

Install drives into the shelf before connecting any cables

Power on the shelf first, then connect only one IOM to a controller

NetAppCertified Implementation Engineer - SAN Specialist, E-Series (NCIE-SAN E-Series)

Domain 3Objective 3

Tasks for Adding Additional Storage to an E-Series System CERTIFIED-IMPLEMENTATION-ENGINEER-SAN-E-SERIES Practice Questions (Page 1)

Part of the Hardware domain, which makes up ~13% of our current practice bank.

19questions here

4free pages

5concepts

Questions 1–5

1foundation · easy
After physically installing a new drive shelf, what is the next step in the installation process?
Select an answer first
2foundation · easy
When configuring newly added drives, what must be created before a volume can be provisioned?
Select an answer first
3expert · hard
A company has added a new drive shelf to an E-Series system. The administrator needs to create a new volume for a critical application that requires high availability and performance. The application will be accessed by two hosts. What should the administrator do?
Select an answer first
4application · medium
An administrator has installed a new drive shelf and connected it to the E-Series controllers. The shelf is powered on, but the SANtricity System Manager shows the shelf as 'unmanaged'. What should the administrator do to make the shelf manageable?
Select an answer first
5foundation · easy
During the physical installation of a new drive shelf, what is the correct procedure for connecting the shelf to the E-Series system?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to CERTIFIED-IMPLEMENTATION-ENGINEER-SAN-E-SERIES

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by NetApp. “CERTIFIED-IMPLEMENTATION-ENGINEER-SAN-E-SERIES” is a trademark of its owner, used for identification only.