Test and Verify Backup Data (SVM:DR) CERTIFIED-CYBER-RESILIENCY-EXPERT Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   An administrator is troubleshooting an SVM DR relationship that is not replicating. The relationship state is 'Out of Sync'. What is the most likely cause?

   • AThe replication schedule is paused.
   • BThe destination SVM is offline.
   • CThe relationship is in a test failover state.
   • DThe last replication transfer failed or was interrupted.
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   After cleaning up an SVM DR test failover, the relationship remains in a 'Test-Failover' state. What is a likely cause?

   • AThe source SVM is offline
   • BThe replication relationship is in the 'In-Sync' state
   • CThe cleanup command was not executed with the correct parameters
   • DThe destination SVM has insufficient storage
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   An administrator has just performed a test failover for an SVM DR relationship. Which action is the most reliable way to confirm that the replicated data is usable and consistent?

   • ACheck the SVM DR relationship status and confirm it is 'InSync'.
   • BConfirm that the replication schedule is still active and has not been paused.
   • CVerify that the source SVM is still serving data without errors.
   • DMount the destination SVM's volumes and run application-level integrity checks on the data.
   Reveal Solution Discussion Select an answer first
5. 14expert · hard

   During an SVM DR test failover, the destination SVM's volumes mount successfully, but the application cannot connect to the database. The administrator checks the network configuration and finds that the destination SVM's data LIFs are not in the same subnet as the application servers. What is the most likely cause of the connectivity issue?

   • AThe destination SVM's data LIFs are not reachable from the application servers due to subnet mismatch.
   • BThe test failover was not cleaned up properly, leaving the destination SVM in a test state.
   • CThe source SVM's data LIFs are still active, causing a conflict with the destination SVM's LIFs.
   • DThe SVM DR relationship is not in an 'InSync' state, so the destination SVM is not fully configured.
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   What is the purpose of performing a test failover on an SVM DR relationship?

   • ATo delete the source SVM data
   • BTo validate that the replicated data can be used without affecting the production SVM
   • CTo measure the network bandwidth between source and destination
   • DTo permanently switch production to the destination SVM
   Reveal Solution Discussion Select an answer first