Test and Verify Backup Data (SVM:DR) CERTIFIED-CYBER-RESILIENCY-EXPERT Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   A company wants to ensure that their SVM DR backup data is reliable and can be used for recovery. What is the best practice to achieve this?

   • AMonitor the replication status and ensure it is always 'InSync'.
   • BStore the backup data on a separate storage system.
   • CIncrease the replication schedule frequency to ensure data is always current.
   • DPerform regular test failovers and verify the replicated data.
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   An administrator is reviewing the SVM DR relationship states and sees that the state is 'Paused'. What does this state indicate?

   • AThe destination SVM is offline.
   • BA test failover is in progress.
   • CReplication has failed and needs to be re-established.
   • DReplication is temporarily stopped and can be resumed manually or by schedule.
   Reveal Solution Discussion Select an answer first
4. 8expert · hard

   After performing an SVM DR test failover, an administrator verifies that the destination SVM's volumes are accessible and the data appears consistent. However, the application on the destination fails to start because it cannot find a required configuration file. What is the most likely cause?

   • AThe destination SVM's volumes are mounted as read-only, preventing the application from reading the configuration file.
   • BThe test failover was not cleaned up properly, causing the configuration file to be deleted.
   • CThe SVM DR relationship is not in an 'InSync' state, so the configuration file was not replicated.
   • DThe configuration file is stored on a volume that is not replicated by the SVM DR relationship.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   Which command is used to monitor the status of SVM DR relationships in ONTAP?

   • Asnapmirror quiesce
   • Bsnapmirror show
   • Csnapmirror release
   • Dsnapmirror update
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   An administrator is monitoring an SVM DR relationship and sees that the 'Last Transfer' time is older than the replication schedule interval. What does this indicate?

   • AThe last scheduled replication transfer did not complete successfully.
   • BThe replication schedule is set to a longer interval than expected.
   • CThe destination SVM is offline.
   • DThe relationship is in a test failover state.
   Reveal Solution Discussion Select an answer first