What is required to implement Azure NAT Gateway for a subnet?

A route table with a default route to the NAT gateway

A VPN gateway and a private IP address

A load balancer and a public IP address

A public IP address and association with the subnet

What is the purpose of a user-defined route (UDR) in Azure?

To provide DNS resolution for custom domain names

To filter traffic based on source and destination IP addresses

To override default system routes and define custom next-hop paths for traffic

To assign private IP addresses to virtual machines

You have a VNet with a subnet that contains VMs. You need to ensure that all outbound internet traffic from these VMs is forced through an on-premises firewall via a site-to-site VPN. You create a route table with a route for 0.0.0.0/0 with next hop 'Virtual network gateway'. What else must you do?

Add a route for the on-premises address space with next hop 'Virtual network gateway'.

Associate the route table with the subnet.

Configure the local network gateway to use the firewall's public IP.

Enable 'Use remote virtual network gateways' on the VNet peering.

You have two virtual networks in the same Azure region. You need to enable communication between resources in these VNets. What is the most direct way to achieve this?

Create a VPN gateway in each VNet and connect them with a site-to-site VPN.

Create an ExpressRoute circuit and connect both VNets to it.

Place an Azure Load Balancer in front of resources in both VNets.

Create a VNet peering connection between the two virtual networks.

Microsoft Certified:Azure Network Engineer Associate

Domain 1Objective 3

Design and Implement VNet Connectivity and Routing AZ-700 Practice Questions (Page 3)

Part of the Design and implement core networking infrastructure domain, which accounts for 25–30% of the AZ-700 exam. Microsoft does not publish an official question count, but from its 100-minute exam (~40–65 total, ~10–20 in this domain), expect 3–5 from this objective — we provide 33 practice questions to prepare you well beyond it. (estimate)

33questions here

7free pages

10concepts

25–30%of the exam

Questions 11–15

11foundation · easy
What is required to implement Azure NAT Gateway for a subnet?
Select an answer first
12foundation · easy
Which next-hop type can you specify in a user-defined route in Azure?
Select an answer first
13foundation · easy
What is the purpose of a user-defined route (UDR) in Azure?
Select an answer first
14application · medium
You have a VNet with a subnet that contains VMs. You need to ensure that all outbound internet traffic from these VMs is forced through an on-premises firewall via a site-to-site VPN. You create a route table with a route for 0.0.0.0/0 with next hop 'Virtual network gateway'. What else must you do?
Select an answer first
15foundation · easy
You have two virtual networks in the same Azure region. You need to enable communication between resources in these VNets. What is the most direct way to achieve this?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to AZ-700

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Microsoft. “AZ-700” is a trademark of its owner, used for identification only.