Configure or Monitor Single-Area or Multi-Area IS-IS with Routing Policy JN0-664 Practice Questions (Page 3)

Questions 11–13

1. 11foundation · easy

   In a multi-area IS-IS network, what is the role of a Level 2 router?

   • AIt only routes within its own area.
   • BIt translates between IS-IS and OSPF.
   • CIt routes between different IS-IS areas.
   • DIt acts as a route reflector for IS-IS.
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   In Junos, which statement correctly applies an import routing policy to IS-IS?

   • Aset policy-options isis import my-policy
   • Bset protocols isis export my-policy
   • Cset protocols isis import my-policy
   • Dset routing-options isis import my-policy
   Reveal Solution Discussion Select an answer first
3. 13application · medium

   You are troubleshooting an IS-IS issue where a router is not forming an adjacency with a neighbor. The 'show isis interface' command shows the interface is up and the level is set to level 1. The neighbor is configured for level 2 only. What is the most likely cause of the adjacency failure?

   • AThe system IDs are the same on both routers.
   • BThe routers are configured for different IS-IS levels.
   • CThe interface MTU is too small.
   • DThe area addresses do not match.
   Reveal Solution Discussion Select an answer first