What is the purpose of configuring a location service in LLDP-MED?

To provide physical location information to media endpoints for emergency services

To configure the voice VLAN on the IP phone

To assign a static IP address to the IP phone

To enable PoE on the switch port

What is the primary purpose of the Link Layer Discovery Protocol (LLDP) in an enterprise network?

To discover and advertise information about directly connected neighbors on the same link

To provide a secure tunnel for remote management traffic

To advertise routing information between autonomous systems

To dynamically assign IP addresses to hosts on a subnet

Which global parameter can be configured for LLDP on a Juniper device?

The IP address of the LLDP server

The OSPF area ID for the LLDP process

The hold time for LLDP advertisements

An engineer is troubleshooting why a Juniper switch is not discovering a neighboring switch via LLDP. The engineer has verified that LLDP is enabled globally and on the interface. What is the next most likely cause to investigate?

The interface is configured as a trunk port.

The neighbor switch has LLDP disabled.

The switch is using LLDP-MED instead of LLDP.

The interface is in a different routing instance.

Juniper NetworksCertified Professional, Enterprise Routing and Switching (JNCIP-ENT)

Domain 6Objective 2

LLDP and LLDP-MED JN0-650 Practice Questions (Page 1)

Part of the IP Telephony Features domain, which makes up ~6% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~2–4 in this domain), expect 1–1 from this objective — we provide 15 practice questions to prepare you well beyond it. (estimate)

15questions here

3free pages

5concepts

Questions 1–5

1foundation · easy
What is the purpose of configuring a location service in LLDP-MED?
Select an answer first
2foundation · easy
What is the primary purpose of the Link Layer Discovery Protocol (LLDP) in an enterprise network?
Select an answer first
3foundation · easy
Which global parameter can be configured for LLDP on a Juniper device?
Select an answer first
4foundation · easy
Which Junos command displays information about LLDP neighbors discovered on a device?
Select an answer first
5application · medium
An engineer is troubleshooting why a Juniper switch is not discovering a neighboring switch via LLDP. The engineer has verified that LLDP is enabled globally and on the interface. What is the next most likely cause to investigate?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-650

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-650” is a trademark of its owner, used for identification only.