Intent-Based Analytics Probes JN0-481 Practice Questions (Page 4)

Questions 16–20

1. 16foundation · easy

   Where should a vTap probe be deployed to monitor traffic between virtual machines on a hypervisor?

   • AOn the analytics engine
   • BOn the hypervisor host
   • COn a dedicated tap device
   • DOn the physical switch
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   In Juniper intent-based analytics, which configuration option allows a probe to capture only specific traffic types, such as HTTP or DNS?

   • AProbe interval
   • BForwarding address
   • CCapture length
   • DFilter expression
   Reveal Solution Discussion Select an answer first
4. 18foundation · easy

   Which protocol is commonly used by intent-based analytics probes to stream telemetry data to the analytics engine?

   • ANetFlow
   • BHTTP
   • CSNMP
   • DgRPC
   Reveal Solution Discussion Select an answer first
5. 19foundation · easy

   When configuring an intent-based analytics probe in Juniper Data Center solutions, which parameter is used to specify the destination for the collected telemetry data?

   • AForwarding address
   • BProbe interval
   • CFilter expression
   • DSource interface
   Reveal Solution Discussion Select an answer first
6. 20expert · hard

   A network engineer is troubleshooting an intent-based analytics probe that is not collecting data. The probe is configured to use gRPC to stream telemetry to an analytics engine. The engineer has verified that the gRPC service is enabled and listening on the correct port, and the probe configuration appears correct. However, no data is being received. What should the engineer check next?

   • AVerify that the analytics engine is configured to accept gRPC connections from the switch's IP address
   • BReboot the switch to reset the gRPC service
   • CCheck if the probe is using the correct sensor name
   • DCheck if the switch has enough memory to run the probe
   Reveal Solution Discussion Select an answer first