Deployment and Connectivity JN0-452 Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   When a switch does not provide sufficient PoE power for a Juniper Mist access point, what is a common alternative to power the AP?

   • AUse a PoE splitter.
   • BUse a longer Ethernet cable.
   • CUse a power injector.
   • DUse a crossover cable.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   Which port must be open on a firewall for Juniper Mist Edge to communicate with the Mist cloud?

   • ATCP 22 (SSH)
   • BTCP 179 (BGP)
   • CUDP 500 (ISAKMP)
   • DTCP 443 (HTTPS)
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which protocol is used by Juniper Mist access points to tunnel traffic to Mist Edge?

   • AVXLAN
   • BGRE
   • CL2TP
   • DIPsec
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   What is the first step to provision a Juniper Mist access point so that it can be managed from the Mist portal?

   • AAssign a static IP address to the access point.
   • BConnect the access point to a switch with a trunk port.
   • CDownload the AP firmware from the Mist portal.
   • DClaim the access point using its serial number.
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   What is the correct sequence for the initial setup of a Juniper Mist-managed WLAN?

   • ACreate a site, then a Mist account, then an organization.
   • BCreate a Mist account, configure an organization, then create a site.
   • CCreate a site, then an organization, then a Mist account.
   • DConfigure an organization, create a Mist account, then create a site.
   Reveal Solution Discussion Select an answer first