Static, Aggregate, and Generated Routes JN0-352 Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What is the purpose of configuring multiple static routes to the same destination with different preferences?

   • ATo create a route with a different next-hop
   • BTo increase the metric of the route
   • CTo load-balance traffic across both routes
   • DTo provide a backup route in case the primary route fails
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   Your routing table contains the following routes: 10.1.0.0/16, 10.2.0.0/16, and 10.3.0.0/16. You want to advertise a single summary route to your upstream provider. What should you configure?

   • AConfigure a static route for 10.0.0.0/8.
   • BConfigure a generated route for 10.0.0.0/8.
   • CConfigure an aggregate route for 10.0.0.0/8.
   • DConfigure a static route for 10.0.0.0/8 with a discard next hop.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which route type has the lowest default preference in Junos?

   • AGenerated
   • BDirect
   • CAggregate
   • DStatic
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   If a static route and an aggregate route both exist for the same destination prefix, which route will be installed in the routing table by default?

   • AThe route with the lower metric
   • BThe aggregate route, because it is more specific
   • CThe route with the higher preference
   • DThe static route, because it has a lower preference
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   When is an aggregate route considered active in the Junos routing table?

   • AWhen at least one contributing more-specific route exists
   • BWhen the aggregate route is advertised to a neighbor
   • CWhen the aggregate route is manually activated with the 'activate' command
   • DWhen the next-hop is reachable
   Reveal Solution Discussion Select an answer first