Examers.io
ExamsOrganizationsHow it worksPricingHelp & FAQ
Juniper Networks logo

Juniper NetworksCertified Specialist, Enterprise Routing and Switching (JNCIS-ENT)

Domain 8Objective 5

Configure, Monitor, or Troubleshoot IP-IP Tunnels JN0-352 Practice Questions (Page 1)

Part of the Tunnels domain, which makes up ~7% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~2–4 in this domain), expect 1–1 from this objective — we provide 13 practice questions to prepare you well beyond it. (estimate)

13questions here
3free pages
4concepts

Questions 1–5

  1. 1foundation · easy

    Which Junos operational command displays the status and statistics of an IP-IP tunnel interface?

    Select an answer first
  2. 2application · medium

    An engineer is troubleshooting an IP-IP tunnel that is not passing traffic. The tunnel interface is up, and the destination is reachable. The engineer suspects that routing is not directing traffic into the tunnel. Which configuration should be checked?

    Select an answer first
  3. 3application · medium

    A network engineer is configuring an IP-IP tunnel between two Junos routers. The tunnel source must be the loopback interface lo0.0 with address 192.0.2.1, and the tunnel destination is 198.51.100.2. The engineer applies the following configuration: set interfaces ip-0/0/0 unit 0 tunnel source 192.0.2.1 set interfaces ip-0/0/0 unit 0 tunnel destination 198.51.100.2 set interfaces ip-0/0/0 unit 0 family inet address 10.0.0.1/30 Which additional configuration is required for the tunnel to be operationally up?

    Select an answer first
  4. 4application · medium

    A Junos router is configured with an IP-IP tunnel to a remote site. Users report that large files fail to transfer, but small packets work fine. The tunnel is up and routing is correct. What is the most likely cause and solution?

    Select an answer first
  5. 5foundation · easy

    Which Junos operational command would you use to verify that the remote endpoint of an IP-IP tunnel is reachable?

    Select an answer first
Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-352” is a trademark of its owner, used for identification only.