Which statement correctly describes the purpose of a BGP peer group in Junos?

It allows multiple neighbors to share common configuration parameters.

It automatically establishes BGP sessions with all routers in the same area.

It is used to define the local AS number for the router.

It is used to filter routes based on AS-path length.

A network engineer is configuring BGP on a Junos router. The router has multiple BGP peers, and the engineer wants to apply common policies to all peers. The engineer decides to use a peer group. Which statement about peer groups is correct?

Peer groups automatically enable multipath for all peers in the group.

Peer groups can only contain peers with the same AS number.

Peer groups allow you to apply common configuration and policies to multiple peers at once.

Peer groups are only used for iBGP peers.

An OSPF adjacency between two Junos routers is stuck in the 'ExStart' state. The engineer has verified that the interface types and timers match. What is the most likely cause of this issue?

The OSPF network type is point-to-multipoint on one router.

The OSPF router IDs are the same.

The OSPF area is configured as a stub on one router.

An engineer is troubleshooting an OSPF issue where a route is not being installed in the routing table. The OSPF neighbor is in Full state, and the route is present in the OSPF database. What should the engineer check next?

Check the routing policy to see if the route is being rejected.

Juniper NetworksCertified Associate, Data Center

Domain 4Objective 4

Configuration and Monitoring JN0-281 Practice Questions (Page 1)

Part of the Data Center Routing Protocols (BGP/OSPF) domain, which makes up ~13% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~5–8 in this domain), expect 1–2 from this objective — we provide 13 practice questions to prepare you well beyond it. (estimate)

13questions here

3free pages

5concepts

Questions 1–5

1foundation · easy
Which statement correctly describes the purpose of a BGP peer group in Junos?
Select an answer first
2foundation · easy
Which operational command displays the state of all BGP sessions on a Junos device?
Select an answer first
3application · medium
A network engineer is configuring BGP on a Junos router. The router has multiple BGP peers, and the engineer wants to apply common policies to all peers. The engineer decides to use a peer group. Which statement about peer groups is correct?
Select an answer first
4expert · hard
An OSPF adjacency between two Junos routers is stuck in the 'ExStart' state. The engineer has verified that the interface types and timers match. What is the most likely cause of this issue?
Select an answer first
5application · medium
An engineer is troubleshooting an OSPF issue where a route is not being installed in the routing table. The OSPF neighbor is in Full state, and the route is present in the OSPF database. What should the engineer check next?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-281

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-281” is a trademark of its owner, used for identification only.