Juniper Mist vBLE Concepts (Asset Visibility, vBLE Engagement) JN0-253 Practice Questions (Page 2)

Questions 6–10

1. 6application · easy

   A hospital is using Mist vBLE to track IV pumps. The administrator needs to replace a faulty IV pump and assign its BLE tag to a new pump. What is the correct procedure in the Mist portal?

   • ADelete the tag from the inventory and add it as a new tag, then assign it to the new pump.
   • BEdit the asset record associated with the tag and change the asset name or ID to reflect the new pump.
   • CRemove the tag from the old pump and assign it to the new pump in the asset management section.
   • DReplace the tag's firmware and then assign it to the new pump.
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   A retail chain wants to send a push notification to shoppers' phones when they enter a specific product aisle. The store has Mist APs with built-in BLE. The marketing team has already defined the campaign and the notification content. What must the administrator configure in the Mist portal to ensure the notification is triggered only when a shopper is physically in that aisle?

   • AConfigure the campaign to use the store's Wi-Fi SSID as the trigger condition.
   • BEnable BLE on the APs and set the transmit power to maximum so the signal covers the entire store.
   • CCreate a zone that maps to the aisle's geographic coordinates and associate it with the engagement campaign.
   • DAssign a unique BLE tag to each product in the aisle and link it to the campaign.
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   A shopping mall wants to send a welcome message and a coupon to shoppers when they enter the mall, and a different message when they are near a specific store. The marketing team has set up the campaign with the correct content. What must the administrator configure in the Mist portal to ensure the correct message is delivered based on the shopper's location?

   • AUse the same zone for both messages and rely on the shopper's phone to filter the content.
   • BCreate a single zone that covers the entire mall and set the campaign to send both messages simultaneously.
   • CDefine two separate zones (mall entrance and store) and associate each with the appropriate campaign message.
   • DConfigure the campaign to trigger on the shopper's Wi-Fi association with the mall's SSID.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   What is a common task in BLE tag management?

   • ACalibrating the access points for location accuracy
   • BDefining the zones for engagement campaigns
   • CUpdating the firmware of the BLE tags
   • DConfiguring the SSID of the access points
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A logistics company is deploying Mist vBLE for asset tracking in a warehouse. The administrator has installed the APs and onboarded the BLE tags. However, the Mist dashboard shows some tags as 'offline' even though they are moving with forklifts. The tags are within range of the APs. What is the most likely cause of this issue?

   • AThe tags are using a different BLE protocol version than the APs support.
   • BThe tags are in a deep sleep state and only transmit when they detect motion, so they are not sending regular advertisements.
   • CThe tags are not transmitting because their advertisement interval is set too low.
   • DThe Mist cloud is unable to process the tags because the APs are not licensed for vBLE.
   Reveal Solution Discussion Select an answer first