An administrator has applied a firewall filter to an interface and is troubleshooting why certain traffic is not being blocked as expected. The administrator wants to see the number of packets that have matched each term in the filter. Which operational command should be used?

show configuration firewall filter

In Junos, where are firewall filters typically evaluated?

At the packet forwarding engine (PFE) as packets traverse an interface

At the routing engine before packets are forwarded

On the control plane for all routing protocol traffic

On the management interface only

An administrator has applied a firewall filter to an interface and wants to verify how many packets have matched each term in the filter. Which operational command provides this information?

show firewall filter block-source

show interfaces ge-0/0/0 extensive

show configuration firewall filter block-source

A network administrator is explaining firewall filters to a junior engineer. The junior engineer asks, 'What is the primary purpose of a firewall filter in Junos?' Which statement correctly describes the purpose?

To route packets between different interfaces based on the destination IP address.

To prioritize certain types of traffic over others based on QoS policies.

To translate private IP addresses to public IP addresses for internet connectivity.

To inspect packets and control whether they are forwarded, discarded, or rejected based on defined match conditions and actions.

Juniper NetworksCertified Associate, Junos

Domain 7Objective 6

Firewall Filters JN0-105 Practice Questions (Page 3)

Part of the Routing Policy and Firewall Filters domain, which makes up ~11% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~4–7 in this domain), expect 1–1 from this objective — we provide 16 practice questions to prepare you well beyond it. (estimate)

16questions here

4free pages

6concepts

Questions 11–15

11application · medium
An administrator has applied a firewall filter to an interface and is troubleshooting why certain traffic is not being blocked as expected. The administrator wants to see the number of packets that have matched each term in the filter. Which operational command should be used?
Select an answer first
12foundation · easy
In Junos, where are firewall filters typically evaluated?
Select an answer first
13application · medium
An administrator has applied a firewall filter to an interface and wants to verify how many packets have matched each term in the filter. Which operational command provides this information?
Select an answer first
14foundation · easy
Which match condition would you use in a firewall filter to match traffic destined to a specific server IP address?
Select an answer first
15application · easy
A network administrator is explaining firewall filters to a junior engineer. The junior engineer asks, 'What is the primary purpose of a firewall filter in Junos?' Which statement correctly describes the purpose?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-105

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-105” is a trademark of its owner, used for identification only.