Configure and Monitor High Availability (HA) NSE6-FORTINAC-ADMINISTRATOR Practice Questions (Page 4)

Questions 16–20

1. 16application · easy

   An organization is planning a FortiNAC deployment with three active units and two standby units. What is this configuration called?

   • AN+M
   • BLoad-balanced cluster
   • CN+1
   • DActive-Passive
   Reveal Solution Discussion Select an answer first
2. 17application · medium

   A FortiNAC HA pair is configured with hot standby. The active unit's management interface becomes unreachable, but the unit continues to process network traffic. The standby unit does not take over. What is the most likely reason?

   • AThe failover trigger is based on the health of the management interface, and it is still up.
   • BThe standby unit is not configured with the same management IP address.
   • CThe standby unit is in a different failover group.
   • DThe active unit is still sending heartbeats over the HA link, so the standby considers it healthy.
   Reveal Solution Discussion Select an answer first
4. 18foundation · easy

   What mechanism does FortiNAC use to detect that the active unit is no longer functioning?

   • AMonitoring the active unit's public IP address
   • BChecking the active unit's CPU usage
   • CReviewing system logs for errors
   • DSending periodic heartbeat messages between HA units
   Reveal Solution Discussion Select an answer first
5. 19application · medium

   A university runs FortiNAC in a hot standby pair. The active unit experiences a hardware failure during a network-wide registration event. The standby unit takes over, but the administrator notices that some recently registered devices are missing from the active sessions list. What is the most likely reason for this?

   • AThe standby unit is in a different VLAN and cannot see the registered devices.
   • BThe standby unit was not fully synchronized at the moment of failure, so it lost the most recent state changes.
   • CThe standby unit did not have the latest configuration because synchronization only occurs every 24 hours.
   • DThe standby unit automatically resets all sessions upon failover to force re-authentication.
   Reveal Solution Discussion Select an answer first
6. 20foundation · easy

   In a FortiNAC N+1 HA configuration, what does the '1' represent?

   • AOne standby unit for a single active unit
   • BOne backup configuration file
   • COne additional active unit for load balancing
   • DOne standby unit that can take over for any of the N active units
   Reveal Solution Discussion Select an answer first