Configure and Monitor High Availability (HA) NSE6-FORTINAC-ADMINISTRATOR Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   What is the main benefit of using FortiNAC HA for load balancing?

   • AIt eliminates the need for a standby unit
   • BIt simplifies the configuration of network devices
   • CIt reduces the number of licenses required
   • DIt increases the total processing capacity of the system
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   In a FortiNAC hot standby HA configuration, what is the primary role of the standby unit?

   • ATo remain idle and ready to assume the active role if the active unit fails
   • BTo provide load balancing by sharing traffic with the active unit
   • CTo serve as a backup for configuration changes only, not for failover
   • DTo actively process network access requests in parallel with the active unit
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   A large enterprise is deploying FortiNAC to manage 50,000 endpoints. They want to ensure high availability and also distribute the processing load across multiple active units. Which HA configuration should they choose?

   • AAn N+M configuration with multiple active and multiple standby units
   • BAn N+1 configuration with one standby unit for multiple active units
   • CA single active unit with one standby unit
   • DA single active unit with multiple standby units
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   What is the main advantage of an N+M FortiNAC HA configuration over N+1?

   • AIt reduces the number of active units required
   • BIt allows multiple standby units, providing higher availability
   • CIt provides load balancing among the standby units
   • DIt eliminates the need for standby units entirely
   Reveal Solution Discussion Select an answer first
6. 5expert · hard

   An administrator is troubleshooting an HA pair where the standby unit shows a 'synchronization failed' status. The administrator suspects a network issue between the units. What is the best way to verify this?

   • APing the HA interface IP of the standby unit from the active unit.
   • BRestart the HA service on both units.
   • CCheck the HA status page for the last synchronization time.
   • DRun a packet capture on the HA link to see if synchronization traffic is being transmitted.
   Reveal Solution Discussion Select an answer first