Configure Switching and Routing on FortiSwitch NSE5-FORTISWITCH-ADMINISTRATOR Practice Questions (Page 5)

Questions 21–25

1. 21expert · hard

   A FortiSwitch is running OSPF with multiple neighbors. The administrator needs to verify that the switch is receiving routes from a specific neighbor. Which command should the administrator use?

   • Aget router info ospf status
   • Bget router info ospf neighbor
   • Cget system performance status
   • Dget router info routing-table all
   Reveal Solution Discussion Select an answer first
2. 22foundation · easy

   What is the primary purpose of Spanning Tree Protocol (STP) on a FortiSwitch?

   • ATo increase the speed of frame forwarding
   • BTo prevent Layer 2 loops by blocking redundant paths
   • CTo provide redundancy by allowing multiple active paths between switches
   • DTo segment the network into multiple broadcast domains
   Reveal Solution Discussion Select an answer first
4. 23application · medium

   A FortiSwitch access port connects to a conference room wall jack. Users frequently unplug the room's IP phone and plug in a small unmanaged switch to connect multiple personal devices. The administrator notices the switch's MAC address table is full and the network is slow. What should the administrator configure on the access port?

   • AEnable MAC address limiting with a maximum of 2 addresses and violation mode 'shutdown'.
   • BEnable BPDU guard on the port.
   • CIncrease the MAC address aging timer to 600 seconds.
   • DSet the port to access mode on VLAN 10.
   Reveal Solution Discussion Select an answer first
5. 24application · medium

   A FortiSwitch has VLAN 10 (192.168.10.0/24) and VLAN 20 (192.168.20.0/24). The administrator creates Layer 3 interfaces for both VLANs with IP addresses 192.168.10.1/24 and 192.168.20.1/24. Users on VLAN 10 can ping 192.168.10.1 but cannot ping 192.168.20.1. What is the most likely cause?

   • AThe switch does not have a route to 192.168.20.0/24.
   • BThe users on VLAN 10 do not have a default gateway.
   • CThe VLAN 20 interface is administratively down.
   • DThe VLAN 20 ports are all down.
   Reveal Solution Discussion Select an answer first
6. 25application · medium

   A company has multiple FortiSwitch switches acting as Layer 3 devices in a campus network. The network has several subnets and the administrator wants to avoid manually configuring static routes on every switch. The routing topology is a single area and all switches are in the same OSPF area. What should the administrator configure?

   • AEnable RIP on each switch instead of OSPF.
   • BCreate a single VLAN interface on each switch and use it for all routing.
   • CConfigure static routes on each switch for every subnet.
   • DEnable OSPF on each switch and advertise the directly connected VLAN interfaces.
   Reveal Solution Discussion Select an answer first