FortinetNSE 5 - FortiSwitch Administrator
Domain 1Objective 4
Configure Switching and Routing on FortiSwitch NSE5-FORTISWITCH-ADMINISTRATOR Practice Questions (Page 2)
Part of the FortiSwitch Concepts domain, which makes up ~45% of our current practice bank.
28questions here
6free pages
8concepts
Questions 6–10
- 6
Which command is used to configure a static route on a FortiSwitch?
Select an answer first - 7
A company has a FortiSwitch with VLAN 10 (192.168.10.0/24) for the finance department and VLAN 20 (192.168.20.0/24) for HR. The administrator needs to allow finance users to reach HR printers. The FortiSwitch is the only Layer 3 device in the network. What must the administrator configure?
Select an answer first - 8
Users on VLAN 10 cannot reach a server on VLAN 20. The administrator checks the FortiSwitch and confirms that both VLANs exist and the Layer 3 interfaces have correct IP addresses. What CLI command should the administrator use to verify that the switch is learning MAC addresses on the VLAN 10 access ports?
Select an answer first - 9
Which dynamic routing protocol is commonly used on FortiSwitch for scalable Layer 3 routing?
Select an answer first - 10
A network administrator connects two FortiSwitch switches together with two cables to provide redundancy. After connecting the second cable, the switches begin flooding traffic and the network becomes unstable. The administrator needs to prevent loops while maintaining redundancy. What should the administrator do?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Fortinet. “NSE5-FORTISWITCH-ADMINISTRATOR” is a trademark of its owner, used for identification only.