An administrator is configuring a FortiSwitch port that connects to an access point. The AP must be on VLAN 20, and the port should only carry that VLAN. Which port type should be configured?

Trunk port with VLAN 20 allowed

Access port with VLAN 20 as the native VLAN

What should you check first when a transceiver is not detected by the FortiSwitch?

Whether the port is configured as a trunk

Whether the VLAN is correctly assigned

Whether the transceiver is firmly seated in the port

Whether the switch firmware is up to date

An administrator has installed a third-party SFP+ transceiver in a FortiSwitch. The switch does not recognize the transceiver. What is the most likely cause?

The transceiver is not on the FortiSwitch's supported transceiver list.

The port is administratively down.

What is the purpose of storm control on a FortiSwitch port?

To limit the rate of broadcast, multicast, or unknown unicast traffic

To authenticate devices before allowing network access

To restrict the number of MAC addresses learned on the port

To isolate the port from other ports in the same VLAN

An administrator is monitoring a FortiSwitch and notices that an SFP+ transceiver is running at a high temperature. What should the administrator do to prevent potential link issues?

Ignore the temperature as long as the link is up.

Disable the port to cool down the transceiver.

Check the transceiver diagnostics and consider replacing the transceiver if it exceeds the recommended temperature range.

Increase the port speed to reduce temperature.

FortinetNSE 5 - FortiSwitch Administrator

Domain 1Objective 6

Configure Switch Ports, Split Port, and Available Transceivers NSE5-FORTISWITCH-ADMINISTRATOR Practice Questions (Page 5)

Part of the FortiSwitch Concepts domain, which makes up ~45% of our current practice bank.

25questions here

5free pages

9concepts

Questions 21–25

21application · easy
An administrator is configuring a FortiSwitch port that connects to an access point. The AP must be on VLAN 20, and the port should only carry that VLAN. Which port type should be configured?
Select an answer first
22foundation · easy
What should you check first when a transceiver is not detected by the FortiSwitch?
Select an answer first
23application · medium
An administrator has installed a third-party SFP+ transceiver in a FortiSwitch. The switch does not recognize the transceiver. What is the most likely cause?
Select an answer first
24foundation · easy
What is the purpose of storm control on a FortiSwitch port?
Select an answer first
25application · medium
An administrator is monitoring a FortiSwitch and notices that an SFP+ transceiver is running at a high temperature. What should the administrator do to prevent potential link issues?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

No more pagesBack to NSE5-FORTISWITCH-ADMINISTRATOR

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Fortinet. “NSE5-FORTISWITCH-ADMINISTRATOR” is a trademark of its owner, used for identification only.