Configure and Route Packets Using Static Routes NSE4-FORTIOS-ADMINISTRATOR Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   What is the default administrative distance for a static route in FortiOS?

   • A20
   • B1
   • C110
   • D10
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   A small office has a FortiGate connected to a single ISP. The internal network is 192.168.1.0/24, and the ISP gateway is 203.0.113.1 on the 'wan1' interface. The admin needs to allow internal users to access the internet. What static route should be configured?

   • AA static route to 192.168.1.0/24 with gateway 203.0.113.1 and interface wan1.
   • BA default route (0.0.0.0/0) with gateway 203.0.113.1 and interface wan1.
   • CA static route to 203.0.113.0/24 with gateway 192.168.1.1 and interface internal.
   • DA static route to 0.0.0.0/0 with gateway 192.168.1.1 and interface internal.
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   Which of the following is a valid use case for static routing?

   • AA network with many routers and complex path selection requirements.
   • BA network that requires automatic rerouting around failed links.
   • CA network where routing tables must be updated dynamically based on traffic load.
   • DA stub network that has only one path to the rest of the network.
   Reveal Solution Discussion Select an answer first
5. 14application · medium

   An admin is configuring redundant static routes to a remote network. The primary route uses gateway 10.0.0.1 on port1, and the backup uses gateway 10.0.0.2 on port2. The admin sets the primary route's distance to 10 and the backup's distance to 20. What will happen if the primary gateway becomes unreachable?

   • ATraffic will be dropped until the primary recovers.
   • BThe backup route will be used automatically.
   • CThe FortiGate will send an ICMP redirect to the backup gateway.
   • DThe FortiGate will use both routes for load balancing.
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   A company has two internet links from different ISPs, both connected to a FortiGate. They want to distribute outbound traffic across both links to maximize bandwidth utilization. They have configured two default static routes, one via each ISP gateway, with the same administrative distance. What else must be configured to ensure traffic is load-balanced across both links?

   • AConfigure a policy route to alternate traffic between the two gateways.
   • BSet different administrative distances for the two routes to allow failover.
   • CEnable 'Load Balance' on the wan1 and wan2 interfaces.
   • DSet the same metric for both routes and enable ECMP (Equal-Cost Multi-Path) load balancing.
   Reveal Solution Discussion Select an answer first