Configure and Route Packets Using Static Routes NSE4-FORTIOS-ADMINISTRATOR Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   In which scenario is static routing most appropriate?

   • AA network with frequent topology changes and many routers.
   • BA large enterprise network with multiple redundant paths that require automatic failover.
   • CA small network with a single connection to the internet and no need for dynamic route updates.
   • DA network where routing decisions must adapt to link failures in real time.
   Reveal Solution Discussion Select an answer first
2. 7expert · hard

   A FortiGate has a static route to 0.0.0.0/0 with distance 10, and an OSPF route to 0.0.0.0/0 with distance 110. The OSPF route is learned from a neighbor that is currently down. What will happen?

   • ABoth routes will be used for load balancing.
   • BThe OSPF route will still be used because it has a lower metric.
   • CThe static route will be used because the OSPF route is removed when the neighbor is down.
   • DTraffic will be dropped because there is no valid default route.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   In the FortiGate routing table output, what does the 'C' flag typically indicate?

   • AA static route
   • BA route learned via OSPF
   • CA connected route
   • DA default route
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   What does the 'distance' value represent in a FortiGate routing table entry?

   • AThe metric of the route, used to compare routes from the same source.
   • BThe physical distance in kilometers to the destination.
   • CThe administrative distance of the route, used to compare routes from different sources.
   • DThe number of hops to the destination network.
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   When two static routes have the same administrative distance and metric to the same destination, how does FortiGate handle traffic?

   • AIt uses the route with the higher interface speed.
   • BIt randomly selects one route for all traffic.
   • CIt uses only the first route configured and ignores the second.
   • DIt load balances traffic across both routes.
   Reveal Solution Discussion Select an answer first