Identify Speed and Duplex F5CAB5 Practice Questions (Page 4)

Questions 16–18

1. 16foundation · easy

   In Ethernet networking, what does the term 'duplex mode' refer to?

   • AThe maximum data rate supported by the cable
   • BThe process of negotiating the highest common speed between two devices
   • CThe ability to send and receive data simultaneously or one direction at a time
   • DThe number of physical wire pairs used in the cable
   Reveal Solution Discussion Select an answer first
2. 17application · medium

   An administrator needs to permanently configure a BIG-IP interface to 1 Gbps full duplex to match a switch that is hard-coded. Which command should they use to make this change persistent?

   • Atmsh set net interface 1.1 speed 1G duplex full
   • Btmsh create net interface 1.1 speed 1G duplex full
   • Ctmsh modify net interface 1.1 speed 1G duplex full
   • Difconfig 1.1 speed 1G duplex full
   Reveal Solution Discussion Select an answer first
3. 18expert · hard

   An administrator is troubleshooting a BIG-IP that is experiencing poor throughput. They have verified the speed and duplex settings on the BIG-IP and the switch, and both are set to 1 Gbps full duplex. The administrator also checks the interface error counters and sees a high number of CRC errors. What is the most likely cause of the poor throughput?

   • AThe MTU is set incorrectly on the BIG-IP.
   • BThe switch is configured for half duplex.
   • CThe network cable is faulty or the connector is damaged, causing physical layer errors.
   • DThe BIG-IP interface is configured for half duplex.
   Reveal Solution Discussion Select an answer first