Explain Management IP Connectivity Issue F5CAB4 Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   A BIG-IP administrator is troubleshooting a management connectivity issue. The management IP is configured, but the admin cannot ping it from a workstation on the same subnet. The admin runs `tcpdump -i mgmt` on the BIG-IP and sees the ping requests arriving, but no replies are sent. What is the most likely cause?

   • AThe BIG-IP's management interface is administratively down.
   • BThe management IP is not configured on the BIG-IP.
   • CThe BIG-IP is configured to ignore ICMP echo requests on the management interface.
   • DThe BIG-IP's management routing table does not have a route to the workstation's subnet.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   How is the management interface isolated from data-plane traffic on a BIG-IP?

   • AIt uses a separate physical port and routing table
   • BIt is only accessible via the console
   • CIt is disabled by default
   • DIt shares the same VLAN as data traffic
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   An administrator is troubleshooting why they cannot reach the BIG-IP management IP from a remote site. The management IP is 10.10.1.5/24, and the default gateway is set to 10.10.1.1. The admin can ping the gateway from the BIG-IP, but cannot ping the management IP from the remote site. What is the most likely cause?

   • AThe remote site does not have a route back to the 10.10.1.0/24 network.
   • BThe management port is assigned to a VLAN that is not allowed on the trunk.
   • CThe BIG-IP's management routing table is missing a default route.
   • DThe management IP is not in the same subnet as the default gateway.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   What is a key difference between accessing the BIG-IP via a self-IP and via the management IP?

   • ASelf-IP access requires the data-plane network; management IP uses a dedicated management network
   • BManagement IP access is only available via the console
   • CSelf-IP access is only for read-only commands
   • DSelf-IP access is faster than management IP
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   Which of the following is a common cause of management IP connectivity failure?

   • AIncorrect VLAN assignment on a self-IP
   • BIncorrect subnet mask on the management IP
   • CMissing default route in the data-plane routing table
   • DToo many virtual servers configured
   Reveal Solution Discussion Select an answer first