Demonstrate Config Sync Procedure F5CAB4 Practice Questions (Page 4)

Questions 16–20

1. 16application · medium

   A BIG-IP admin is troubleshooting a config sync failure between two devices in a device group. The devices are in the same data center, and the admin can ping the management IP of each device from the other. The device trust appears to be intact. What should the admin check next?

   • AVerify that both devices are running the same BIG-IP version.
   • BCheck if the devices are in the same VLAN.
   • CEnsure that the active device has a floating IP address.
   • DConfirm that the standby device has a valid license.
   Reveal Solution Discussion Select an answer first
2. 17application · medium

   An organization is setting up a new BIG-IP device group for config sync. The two devices are in different network segments, and the admin has already established device trust. What else must be verified before attempting the first config sync?

   • AThe devices have the same default gateway.
   • BThe devices are in the same DNS domain.
   • CThe devices have the same hostname.
   • DThe devices can communicate over the management network on the config sync port.
   Reveal Solution Discussion Select an answer first
4. 18foundation · easy

   After making configuration changes on a BIG-IP device, what is the manual UI action to push those changes to a peer device?

   • AClick the Sync button on the Device Management > Overview screen.
   • BClick the Activate button on the Local Traffic > Virtual Servers screen.
   • CClick the Save button on the System > Configuration screen.
   • DClick the Refresh button on the Network > Interfaces screen.
   Reveal Solution Discussion Select an answer first
5. 19application · medium

   A BIG-IP admin is troubleshooting a config sync failure. The devices are in the same device group, trust is intact, and the network is reachable. The admin notices that the active device is running version 15.1.0 and the standby is running 15.1.0.1. What is the most likely issue?

   • AThe config sync port is blocked.
   • BThe version mismatch is preventing the sync.
   • CThe device group is not configured correctly.
   • DThe standby device is not licensed.
   Reveal Solution Discussion Select an answer first
6. 20foundation · easy

   A config sync fails between two BIG-IP devices. Which of the following is a common cause of sync failure?

   • AThe devices have different hostnames.
   • BA software version mismatch between the devices.
   • CThe devices are in different data centers.
   • DThe devices have different management IP addresses.
   Reveal Solution Discussion Select an answer first