Objective 2.10 Explain the Necessary Steps and Tools to Add a New GTM to an Existing Sync Group 302 Practice Questions (Page 2)

Questions 6–8

1. 6expert · hard

   An administrator is adding a new GTM to an existing sync group. The existing sync group has a GTM at the headquarters and a GTM at a regional office. The new GTM is at a new remote site. The administrator runs gtm_add on the new GTM, specifying the headquarters GTM as the peer. The command completes successfully, but the new GTM does not have the same wide IP configuration as the headquarters GTM. The administrator has verified that the sync status shows 'in sync'. What is the most likely cause of this discrepancy?

   • AThe new GTM was added to the sync group, but the wide IP configuration was not synchronized because of a network issue.
   • BThe wide IP configuration was not present on the headquarters GTM at the time of synchronization.
   • CThe new GTM is in a different data center, so it has a different wide IP configuration.
   • DThe headquarters GTM has a different version of the BIG-IP software than the new GTM.
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   An administrator is adding a new GTM to an existing sync group. The new GTM is at a remote site, and the existing GTM is at the headquarters. The administrator runs the gtm_add command on the new GTM, but the command fails because it cannot reach the existing GTM. The administrator has verified that the IP address is correct and that the network route is in place. What else should the administrator check?

   • ACheck that the existing GTM is listening on the required port for gtm_add.
   • BEnsure that the existing GTM has the gtm_add utility installed.
   • CVerify that the new GTM has a valid license for the GTM module.
   • DConfirm that the existing GTM is not already at the maximum number of sync group members.
   Reveal Solution Discussion Select an answer first
3. 8application · medium

   An administrator is adding a new GTM to an existing sync group. The new GTM is at a remote site and the existing sync group is at the headquarters. The administrator has run the gtm_add command on the new GTM and specified the IP address of the existing GTM. The command fails with a connection error. What is the most likely cause of this failure?

   • AThe new GTM has not been licensed for the GTM module.
   • BThe new GTM does not have a route to the existing GTM's management IP address.
   • CThe existing GTM is already at the maximum number of sync group members.
   • DThe existing GTM is not running the same version of BIG-IP DNS software.
   Reveal Solution Discussion Select an answer first