F5Certified Technology Specialist, BIG-IP DNS
Domain 2Objective 10
Objective 2.10 Explain the Necessary Steps and Tools to Add a New GTM to an Existing Sync Group 302 Practice Questions (Page 1)
Part of the Section 2: Deployment domain, which makes up ~30% of our current practice bank.
8questions here
2free pages
3concepts
Questions 1–5
- 1
What is the correct syntax for the gtm_add utility when adding a new GTM to an existing sync group?
Select an answer first - 2
When adding a new BIG-IP DNS (GTM) system to an existing data center in a deployment, what is the first step that must be completed on the new GTM before it can be added to the sync group?
Select an answer first - 3
When adding a new GTM to an existing sync group using the gtm_add utility, on which system should the command be executed?
Select an answer first - 4
A company is adding a new GTM to an existing sync group. The new GTM is located in a data center that is already defined in the existing configuration. The administrator runs gtm_add on the new GTM, specifying the existing GTM as the peer. After the command completes, what should the administrator do to ensure the new GTM is fully operational?
Select an answer first - 5
An administrator is adding a new GTM to an existing sync group. They have run the gtm_add command on the new GTM, specifying the existing GTM's IP address. The command completes successfully, but the new GTM does not have the same wide IP configuration as the existing GTM. What should the administrator check first?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by F5. “302” is a trademark of its owner, used for identification only.