Describe Additional Network Consideration. VXRAIL-DESIGN Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   What is the primary purpose of NIC teaming in a VxRail deployment?

   • ATo reduce the IP address requirements for the host
   • BTo enable jumbo frames on the network
   • CTo increase the number of VLANs available to the host
   • DTo provide redundancy and failover for network connectivity
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   Which traffic type in a VxRail deployment is typically placed on a dedicated VLAN to prevent performance degradation from other network traffic?

   • AvSAN traffic
   • BvMotion traffic
   • CVM traffic
   • DManagement traffic
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   Which best practice is recommended for vMotion networking in a VxRail deployment?

   • AUse a dedicated VLAN and physical NICs for vMotion traffic
   • BDisable vMotion networking to improve security
   • CUse the vSAN network for vMotion to reduce the number of VLANs
   • DUse the same VLAN as the management network to simplify configuration
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   What is a recommended practice for the vSAN network in a VxRail deployment?

   • APlace vSAN traffic on a dedicated VLAN and use separate physical NICs
   • BUse the management network for vSAN traffic to reduce complexity
   • CUse a single network for both vSAN and vMotion to save ports
   • DConfigure vSAN traffic to use the default VM network
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   You are designing the vSAN network for a VxRail cluster that will host a mix of VMs, including some with high I/O requirements. The network team has allocated a dedicated 10 Gbps VLAN for vSAN. What is the most important design consideration to ensure vSAN performance?

   • AUse a 1 Gbps link for vSAN and reserve the 10 Gbps link for VM traffic.
   • BEnsure the vSAN VLAN is configured with jumbo frames (MTU 9000) and that the physical switches support it.
   • CConfigure the vSAN network with a smaller MTU (e.g., 1500) to reduce latency.
   • DPlace the vSAN network on the same VLAN as vMotion to simplify the network configuration.
   Reveal Solution Discussion Select an answer first