Dell VxRail Deploy v2
Domain 4Objective 3
Configure VxRail Node iDRAC and System Time VXRAIL-DEPLOY-V2 Practice Questions (Page 3)
Part of the VxRail Hardware Installation and Initialization domain, which accounts for 8% of the VXRAIL-DEPLOY-V2 exam.
18questions here
4free pages
5concepts
8%of the exam
Questions 11–15
- 11
Which method is commonly used to assign an IP address to the iDRAC on a VxRail node during initial deployment?
Select an answer first - 12
A technician is configuring the iDRAC network settings on a VxRail node. Which parameter is NOT part of the basic iDRAC network configuration?
Select an answer first - 13
An administrator is configuring iDRAC security on a VxRail node. The company requires that iDRAC access be restricted to a specific management subnet and that all communication be encrypted. Which configuration should the administrator apply?
Select an answer first - 14
After configuring iDRAC settings on a VxRail node, what is the first step to verify that the settings are correctly applied?
Select an answer first - 15
An administrator is configuring the iDRAC on a VxRail node for out-of-band management. The management network uses static IP addressing, and the administrator has been given the IP address 10.10.20.15, subnet mask 255.255.255.0, and gateway 10.10.20.1. After applying these settings, the administrator can ping the iDRAC from a workstation on the same subnet, but cannot reach it from a workstation on a different subnet. What is the most likely cause?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “VXRAIL-DEPLOY-V2” is a trademark of its owner, used for identification only.