Multicast POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 5)

Questions 21–24

1. 21foundation · easy

   Which OS10 command shows the PIM neighbor state on an interface?

   • Ashow pim neighbors
   • Bdisplay ip pim neighbor
   • Cshow ip pim neighbor
   • Dshow multicast pim neighbor
   Reveal Solution Discussion Select an answer first
2. 22expert · medium

   A Dell OS10 switch is configured as the RP for PIM sparse-mode. The network has two multicast groups: 239.1.1.0/24 and 239.2.2.0/24. The administrator wants to use the same RP for both groups but needs to verify that the RP is serving both. The 'show ip pim rp mapping' command shows only one group range. What is the most likely reason?

   • AThe RP is not reachable from the first-hop router for the second group.
   • BPIM is not enabled on the interface facing the second group's receivers.
   • CThe second group is using a different multicast routing protocol.
   • DThe RP configuration only includes one group range; the other group is not mapped to the RP.
   Reveal Solution Discussion Select an answer first
4. 23foundation · easy

   Which OS10 command configures a static Rendezvous Point (RP) for a multicast group?

   • Aset pim rp 10.1.1.1
   • Bip pim rendezvous-point 10.1.1.1
   • Cpim rp 10.1.1.1
   • Dip pim rp-address 10.1.1.1
   Reveal Solution Discussion Select an answer first
5. 24foundation · easy

   In PIM sparse mode, what is the role of a Rendezvous Point (RP)?

   • AIt acts as a meeting point where sources and receivers can discover each other.
   • BIt encrypts multicast traffic between sources and receivers.
   • CIt floods all multicast traffic to every router in the network.
   • DIt translates multicast addresses to unicast addresses.
   Reveal Solution Discussion Select an answer first