Identify VRRP Components POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   What is the initial state of a VRRP router when it first becomes active on an interface?

   • ADisabled
   • BMaster
   • CInitialize
   • DBackup
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   A data center team is configuring VRRP on two Dell PowerSwitch switches. They want Switch A to be the Master under normal conditions. They set Switch A's priority to 120 and Switch B's priority to 100. Both switches have preemption enabled. After a maintenance window, both switches reboot simultaneously. Which switch becomes Master, and why?

   • ASwitch A becomes Master because it has the higher priority.
   • BSwitch B becomes Master because it boots faster and starts advertising first.
   • CThe switch with the higher IP address becomes Master.
   • DThe switch that sends the first advertisement becomes Master and remains Master.
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   In a VRRP deployment, what role does the virtual IP address play for end hosts?

   • AIt is the physical IP address of the Master router
   • BIt is the IP address of the backup router
   • CIt is the default gateway address configured on the hosts
   • DIt is used only for management access to the routers
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   What is the primary purpose of Virtual Router Redundancy Protocol (VRRP) in a network?

   • ATo filter traffic between VLANs based on security policies
   • BTo provide redundancy for the default gateway by allowing multiple routers to share a virtual IP address
   • CTo load-balance traffic across multiple routers by distributing individual host default gateways
   • DTo replace the need for a default gateway by allowing hosts to route directly to each other
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   What is the purpose of the virtual MAC address in a VRRP group?

   • AIt allows hosts to send frames to the virtual router without needing to know the active router's physical MAC
   • BIt is used for management traffic between VRRP routers
   • CIt is the MAC address of the backup router
   • DIt is used to uniquely identify each physical router in the group
   Reveal Solution Discussion Select an answer first