A network administrator configured PBR on a Dell PowerSwitch to send VoIP traffic (source 192.168.10.0/24) to a WAN optimizer at 10.0.0.2. After applying the route map to the interface, the administrator notices that VoIP traffic is still using the default route. Which verification step should the administrator perform first to isolate the issue?

Check the route map configuration with 'show route-map' to confirm the match and set clauses are correctly defined.

Reboot the switch to ensure the PBR configuration is loaded into the hardware forwarding table.

Verify that the WAN optimizer at 10.0.0.2 is reachable using 'ping 10.0.0.2'.

Check the interface statistics with 'show interfaces' to see if the interface is up and receiving traffic.

Which two components are typically used to configure Policy-Based Routing (PBR) on a Dell PowerSwitch?

Static routes and administrative distance

Prefix lists and route redistribution

In which scenario is Policy-Based Routing (PBR) most appropriately used?

To dynamically learn routes from neighboring routers

To filter traffic based on security policies

To send traffic from a specific application over a dedicated high-bandwidth link

To route all traffic to a single default gateway

In a PBR configuration, what is the purpose of the 'set ip next-hop' command within a route map?

To define the destination IP address for the traffic

To create a static route for the traffic

To specify the next-hop router to which matching traffic should be forwarded

To enable IP routing on the interface

What is the primary purpose of Policy-Based Routing (PBR) in a network?

To provide redundancy by failing over to a backup path when a primary link goes down

To forward packets based on criteria other than the destination IP address, such as source address or application

To automatically adjust routing metrics based on link utilization

To replace the routing table with a set of static routes for all traffic

Dell PowerSwitch Data Center Deploy

Domain 4Objective 6

Describe Policy-Based Routing (PBR) Basic Operations POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 2)

Part of the IP Routing domain, which accounts for 20% of the POWERSWITCH-DATA-CENTER-DEPLOY exam.

13questions here

3free pages

3concepts

20%of the exam

Questions 6–10

6application · medium
A network administrator configured PBR on a Dell PowerSwitch to send VoIP traffic (source 192.168.10.0/24) to a WAN optimizer at 10.0.0.2. After applying the route map to the interface, the administrator notices that VoIP traffic is still using the default route. Which verification step should the administrator perform first to isolate the issue?
Select an answer first
7foundation · easy
Which two components are typically used to configure Policy-Based Routing (PBR) on a Dell PowerSwitch?
Select an answer first
8foundation · easy
In which scenario is Policy-Based Routing (PBR) most appropriately used?
Select an answer first
9foundation · easy
In a PBR configuration, what is the purpose of the 'set ip next-hop' command within a route map?
Select an answer first
10foundation · easy
What is the primary purpose of Policy-Based Routing (PBR) in a network?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWERSWITCH-DATA-CENTER-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWERSWITCH-DATA-CENTER-DEPLOY” is a trademark of its owner, used for identification only.