Discover and Perform Initial System Configuration of PowerStore. POWERSTORE-DEPLOY Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   Which network parameters must be configured during the initial network setup of a PowerStore appliance?

   • AHostname, domain name, and NTP server
   • BManagement IP, subnet mask, gateway, and DNS
   • CVLAN ID, MTU size, and port speed
   • DStorage IP, iSCSI IQN, and Fibre Channel WWN
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   An administrator is configuring the initial network settings for a PowerStore appliance. The appliance will be managed from a dedicated management network. The administrator enters the management IP, subnet mask, gateway, and DNS in the PowerStore Manager setup wizard. After the appliance reboots, the administrator cannot access PowerStore Manager. What is the most likely cause?

   • AThe gateway address is incorrect, preventing routing to the management network.
   • BThe DNS server is not reachable from the management network.
   • CThe appliance did not save the configuration because the administrator did not click 'Apply'.
   • DThe management IP address is not in the same subnet as the administrator's workstation.
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   Which of the following is an example of verifying connectivity during the initial configuration verification?

   • AChecking the physical power LED on the appliance
   • BPinging the management IP address from a client on the same network
   • CReviewing the storage pool capacity
   • DVerifying the administrator password complexity
   Reveal Solution Discussion Select an answer first
5. 14application · medium

   An administrator is performing the initial setup of a PowerStore appliance. The administrator has completed the network configuration and is now in the setup wizard. The wizard asks for the system name, time zone, and administrator password. The administrator wants to ensure that the system time is accurate for logging and certificate validation. What should the administrator do?

   • ASet the time zone and manually enter the current time in the wizard.
   • BSkip the time settings and configure them later after the cluster is created.
   • CConfigure NTP servers during the setup wizard to synchronize time automatically.
   • DUse the default time zone and time, as they are usually correct.
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   An administrator has completed the initial configuration of a PowerStore cluster. To verify the configuration, the administrator checks the system status in PowerStore Manager and sees that the cluster is healthy. However, the administrator cannot connect to the cluster from a host on a different subnet. What should the administrator check?

   • AEnsure that the cluster's DNS settings are correct.
   • BReboot the cluster to refresh the network configuration.
   • CCheck that the storage pool is initialized and has available capacity.
   • DVerify that the gateway and routing are correctly configured on the cluster's management network.
   Reveal Solution Discussion Select an answer first