Configure the Migration Feature to Import Data from Supported Sources. POWERSTORE-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   An organization is migrating LUNs from a Dell EMC VNX5800 to a PowerStore 500T. The storage team has configured the Fibre Channel zones so that the VNX's storage processors can see the PowerStore's initiator ports. However, when creating a migration session, the wizard reports that the source and destination are not connected. What is the most likely cause?

   • AThe Fibre Channel zones are missing the PowerStore's target ports.
   • BThe VNX is not running the minimum supported version.
   • CThe PowerStore appliance is not registered as a remote system.
   • DThe VNX storage processors are not zoned to the PowerStore's management ports.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   What action can be taken on an ongoing migration session if you need to temporarily stop the data transfer?

   • ARestart the PowerStore appliance
   • BPause the migration session
   • CDelete the migration session
   • DDisable the source array
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   A storage admin is preparing to migrate volumes from a Dell EMC VNX2 to a PowerStore 500T. The admin has verified that the VNX2 is running a supported version and that the Fibre Channel zones are correct. However, the migration wizard reports that the source array is not reachable. What should the admin check first?

   • AConfirm that the VNX2 is running the latest firmware.
   • BVerify that the VNX2 management IP is reachable from the PowerStore management network.
   • CEnsure that the PowerStore has a valid license for migration.
   • DCheck that the VNX2 has enough free space for the migration.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   Which of the following is a prerequisite for starting a PowerStore migration?

   • AThe source and destination arrays are in the same data center
   • BThe destination PowerStore appliance has sufficient capacity to accommodate the source data
   • CThe source array is powered off during migration
   • DThe migration is performed during a maintenance window
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A company is migrating a file server volume from a Dell EMC VNX to a PowerStore. The migration session is in the 'Ready for Cutover' state. The storage admin has verified that the host can see the PowerStore volume and that the data is consistent. What is the final step the admin should perform to complete the migration?

   • ACreate a new migration session to refresh the copy.
   • BDelete the source volume from the VNX to free up space.
   • CPause the session to keep the source as the active path.
   • DExecute the cutover and then verify host access to the PowerStore volume.
   Reveal Solution Discussion Select an answer first