In PowerScale, what is a subnet in the context of network configuration?

A collection of network interfaces on a single node

A group of IP pools that share the same VLAN and routing configuration

A set of IP addresses used only for backend communication

A physical network segment that connects all nodes in the cluster

What is the purpose of an IP pool in PowerScale networking?

To group network interfaces and IP addresses for management and client access

To assign a single IP address to the entire cluster for all client connections

To provide a dedicated IP address for each node's backend interface

To route traffic between different VLANs on the cluster

An administrator notices that after a network interface failure on one node, the IP addresses from that interface do not appear on any other interface. The IP pool has failover enabled. What is the most likely cause?

The load balancing policy is set to 'static'.

The other interfaces in the pool are not configured to accept failover addresses.

The subnet is not configured with the correct VLAN ID.

The DNS server is not reachable.

What is the purpose of VLAN tagging in a PowerScale network configuration?

To assign IP addresses to nodes automatically

To allow multiple logical networks to share the same physical switch ports

To provide a backup path for network traffic

To increase the speed of the network interface

When would you need to configure a static route on a PowerScale cluster?

When the cluster needs to communicate with a network that is not directly connected

When enabling failover on an IP pool

When configuring VLAN tagging on the switch

When the cluster has multiple IP pools on the same subnet

Dell PowerScale Maintenance v2

Domain 1Objective 3

Set up PowerScale Networking POWERSCALE-MAINTENANCE Practice Questions (Page 1)

Part of the PowerScale Hardware Concepts domain, which accounts for 25% of the POWERSCALE-MAINTENANCE exam.

19questions here

4free pages

6concepts

25%of the exam

Questions 1–5

1foundation · easy
In PowerScale, what is a subnet in the context of network configuration?
Select an answer first
2foundation · easy
What is the purpose of an IP pool in PowerScale networking?
Select an answer first
3application · medium
An administrator notices that after a network interface failure on one node, the IP addresses from that interface do not appear on any other interface. The IP pool has failover enabled. What is the most likely cause?
Select an answer first
4foundation · easy
What is the purpose of VLAN tagging in a PowerScale network configuration?
Select an answer first
5foundation · easy
When would you need to configure a static route on a PowerScale cluster?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWERSCALE-MAINTENANCE

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWERSCALE-MAINTENANCE” is a trademark of its owner, used for identification only.