A technician replaced a failed I/O module in a PowerMax array. The module's status in Unisphere shows 'OK', but the event log shows a 'link down' error on one of the ports. The technician reconnected all cables. What should the technician do NEXT?

Reseat the cable on the affected port and verify the link status.

Replace the I/O module again because it is faulty.

Run a full array reboot to clear the error.

Ignore the error because the module status is 'OK'.

When replacing a power supply FRU in a PowerMax system, what should be done after removing the failed unit?

Disconnect all data cables from the backplane

Insert the replacement power supply and ensure it is fully seated

Immediately power on the system

Which component in a Dell PowerMax system is considered a Field Replaceable Unit (FRU)?

Pre-installed software license key

A technician is replacing a failed I/O module in a PowerMax director. After removing the failed module, the technician inserts the new module. What is the correct NEXT step in the procedure?

Power on the director to test the new module.

Run a diagnostic test on the new module before reconnecting cables.

Reconnect any cables that were disconnected and ensure they are properly seated.

Update the array's firmware to support the new module.

A technician is replacing a failed disk drive in a PowerMax array. The drive is part of a RAID 5 group. The technician has the replacement drive and has confirmed the part number. However, the RAID group is currently in a degraded state because another drive in the same group failed earlier. What should the technician do?

Replace the failed drive immediately to restore the RAID group to a healthy state.

Wait for the other failed drive to be replaced first.

Replace both drives at the same time to save time.

Back up the RAID group before replacing the drive.

Dell PowerMax Maintenance

Domain 4Objective 3

Discuss Field Replaceable Units (FRUs) Replacement and Related Procedures POWERMAX-MAINTENANCE Practice Questions (Page 1)

Part of the PowerMax Maintenance domain, which accounts for 30% of the POWERMAX-MAINTENANCE exam.

25questions here

5free pages

4concepts

30%of the exam

Questions 1–5

1expert · hard
A technician replaced a failed I/O module in a PowerMax array. The module's status in Unisphere shows 'OK', but the event log shows a 'link down' error on one of the ports. The technician reconnected all cables. What should the technician do NEXT?
Select an answer first
2foundation · easy
When replacing a power supply FRU in a PowerMax system, what should be done after removing the failed unit?
Select an answer first
3foundation · easy
Which component in a Dell PowerMax system is considered a Field Replaceable Unit (FRU)?
Select an answer first
4application · medium
A technician is replacing a failed I/O module in a PowerMax director. After removing the failed module, the technician inserts the new module. What is the correct NEXT step in the procedure?
Select an answer first
5expert · hard
A technician is replacing a failed disk drive in a PowerMax array. The drive is part of a RAID 5 group. The technician has the replacement drive and has confirmed the part number. However, the RAID group is currently in a degraded state because another drive in the same group failed earlier. What should the technician do?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWERMAX-MAINTENANCE

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWERMAX-MAINTENANCE” is a trademark of its owner, used for identification only.