Replicate Volumes Between Clusters POWERFLEX-OPERATE Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   What is specified when configuring a replication pair in PowerFlex?

   • AThe source and target volumes
   • BThe network path between clusters
   • CThe failover target cluster
   • DThe storage pool for the source volume
   Reveal Solution Discussion Select an answer first
2. 12expert · hard

   A replication session is in an 'Error' state. The administrator has verified that the network is healthy, the source and target clusters are online, and the replication license is valid. The error message indicates a 'target volume not found' error. What is the most likely cause of this error?

   • AThe target volume was deleted or is offline on the target cluster
   • BThe replication pair was reconfigured with a different target volume
   • CThe replication session was stopped and restarted incorrectly
   • DThe source volume is too large for the target volume
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   A company wants to implement a disaster recovery solution for its PowerFlex storage. The primary requirement is to have a copy of the data at a remote site that can be used to restore operations quickly in case of a site failure. The company also wants to minimize the impact on production performance. What is the primary benefit of using PowerFlex volume replication for this scenario?

   • AIt provides a backup of the data that can be used for point-in-time recovery
   • BIt provides a way to migrate data between clusters without downtime
   • CIt provides an asynchronous copy of data at the remote site for disaster recovery
   • DIt provides a synchronous copy of data at the remote site for zero data loss
   Reveal Solution Discussion Select an answer first
5. 14application · medium

   An administrator has created a replication consistency group. The administrator now needs to add a volume to this group so it can be replicated. What is the correct procedure to add the volume to the consistency group?

   • AAdd the target volume from the target cluster to the consistency group
   • BSelect the consistency group and add the source volume from the source cluster
   • CThe volume is automatically added when the replication session starts
   • DCreate a replication pair and then add the pair to the consistency group
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   What is the purpose of performing a failover in PowerFlex replication?

   • ATo delete the replication configuration
   • BTo make the target cluster the active cluster in a disaster scenario
   • CTo increase the replication speed
   • DTo create a snapshot of the source volume
   Reveal Solution Discussion Select an answer first