Replicate Volumes Between Clusters POWERFLEX-OPERATE Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   Which benefit does volume replication between PowerFlex clusters provide for data protection?

   • AIt ensures data is available on a secondary cluster in case the primary cluster fails
   • BIt automatically increases the performance of the source cluster
   • CIt reduces the total cost of storage by using only one copy of data
   • DIt eliminates the need for any backup solution
   Reveal Solution Discussion Select an answer first
2. 2expert · hard

   A company has a PowerFlex replication setup. A disaster occurs at the primary site, and the administrator performs a failover to the DR site. The application is running on the DR site. The primary site is later restored, and the administrator wants to failback. The administrator notices that the replication session is in a 'Stopped' state. What is the correct first step to initiate the failback process?

   • AReverse the replication direction so the DR site becomes the source
   • BPerform a failover on the primary cluster to make it active
   • CStart the original replication session from the primary to the DR site
   • DDelete the replication pair and create a new one from primary to DR
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   What is the purpose of monitoring replication health in PowerFlex?

   • ATo detect issues that could impact data protection
   • BTo delete replication sessions
   • CTo change the replication RPO
   • DTo increase the replication speed
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   What action is performed to temporarily stop replication without deleting the replication configuration?

   • AStop the replication session
   • BFailover to the target
   • CRemove the volume from the consistency group
   • DDelete the replication pair
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   A storage administrator has configured a replication pair for a critical volume. The initial synchronization is complete, and the replication session is active. The administrator notices that the replication lag is increasing over time. What is the most appropriate action to investigate and potentially resolve this issue?

   • AStop the replication session and restart it to reset the lag
   • BMonitor the replication session's health and performance metrics to identify bottlenecks
   • CDelete the replication pair and recreate it
   • DIncrease the number of volumes in the consistency group
   Reveal Solution Discussion Select an answer first