Perform Visual Inspections in Cases Where Automated Monitoring Is Unavailable POWEREDGE-XE-OPERATE Practice Questions (Page 1)

Questions 1–5

1. 1foundation · medium

   Which action is part of a systematic visual check of server hardware?

   • ATesting network connectivity with a ping command
   • BVerifying that all cables are securely connected and undamaged
   • CUpdating the firmware to the latest version
   • DReviewing the server's log files for errors
   Reveal Solution Discussion Select an answer first
2. 2application · medium

   A data center technician is performing a visual inspection of a PowerEdge server that was recently moved. The technician notices that one of the SAS cables connecting the backplane to the controller is not fully seated and has a visible kink. What should the technician do?

   • ADocument the finding but do not touch the cable because the server is running.
   • BPower down the server and replace the entire backplane because the cable is connected to it.
   • CReplace the cable immediately because any kink indicates permanent damage.
   • DReseat the cable and straighten the kink, then verify the connection is secure.
   Reveal Solution Discussion Select an answer first
4. 3foundation · medium

   Which scenario most likely requires a visual inspection because automated monitoring is unavailable?

   • AA server is under heavy load but still responding to ping requests.
   • BA server is in a remote data center with out-of-band management enabled.
   • CA server is powered off and disconnected from the network for maintenance.
   • DA server is running normally and sending health metrics to a central dashboard.
   Reveal Solution Discussion Select an answer first
5. 4expert · hard

   A technician is performing a visual inspection of a PowerEdge server and notices that the system status LED is blinking amber, and the power LED is solid green. The server is running but the technician cannot access iDRAC. What should the technician do?

   • ADocument the LED states and attempt to access the server's console to check for errors.
   • BPower cycle the server to clear the fault.
   • CIgnore the blinking amber LED because the server is running.
   • DReplace the power supply because the power LED is solid green.
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   A remote branch office has no network connectivity to the central management console, and the local IT generalist reports that a PowerEdge server's front panel shows a solid amber system health LED. The server is still running, but the generalist cannot access iDRAC. What should the generalist do first?

   • AImmediately replace the power supply unit because a solid amber LED always indicates a PSU failure.
   • BPerform a systematic visual inspection of the server's LEDs, cables, and physical components, and record the findings.
   • COpen the server chassis and reseat all internal components, then power cycle the server.
   • DIgnore the LED because the server is still running, and wait for network connectivity to be restored.
   Reveal Solution Discussion Select an answer first