Perform Health Checks of Hardware Components POWEREDGE-XE-OPERATE Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What does a 'fan speed' reading in iDRAC indicate?

   • AThe temperature of the CPU
   • BThe power consumption of the fan
   • CThe rotational speed of the cooling fan in RPM
   • DThe airflow volume in the chassis
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   Which component is responsible for managing physical disks in a RAID configuration?

   • APower supply unit
   • BProcessor
   • CRAID controller
   • DMemory module
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which parameter is important to verify for a network interface to ensure it is operating at expected speeds?

   • ASubnet mask
   • BIP address
   • CMAC address
   • DLink speed (e.g., 10 Gbps)
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   What does a 'processor status: OK' in iDRAC indicate?

   • AThe processor is functioning correctly without thermal or performance issues
   • BThe processor is in a power-saving mode
   • CThe processor is not installed
   • DThe processor is running at maximum speed
   Reveal Solution Discussion Select an answer first
6. 10expert · medium

   A Dell PowerEdge XE server has two 10GbE NICs. NIC 1 is connected to a switch port configured for 1 Gbps, and NIC 2 is connected to a switch port configured for 10 Gbps. The administrator notices that NIC 1 is operating at 1 Gbps and NIC 2 is operating at 10 Gbps. What should the administrator do to ensure both NICs operate at 10 Gbps?

   • ASwap the cables between NIC 1 and NIC 2.
   • BReconfigure the switch port for NIC 1 to 10 Gbps and verify the cable supports 10GbE.
   • CReplace NIC 1 with a newer model that supports 10GbE.
   • DUpdate the firmware on NIC 1 to enable 10GbE.
   Reveal Solution Discussion Select an answer first