Understand MX7000 Troubleshooting (e.g., Minimum to POST and Alerts) POWEREDGE-MX-MODULAR-DEPLOY Practice Questions (Page 4)

Questions 16–20

1. 16application · easy

   During a routine maintenance, an MX7000 chassis is powered off and then powered back on. The LCD shows 'POST completed successfully' and the chassis status LED is solid blue. What does this indicate?

   • AThe chassis is in standby mode and not fully powered.
   • BThe chassis has completed POST and is operating normally.
   • CThe chassis has a warning alert that needs to be reviewed.
   • DThe chassis is in a degraded state and needs attention.
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   Which display on the MX7000 front panel provides POST status messages and alert information?

   • ALCD panel
   • BSeven-segment display
   • CVGA monitor
   • DOLED touchscreen
   Reveal Solution Discussion Select an answer first
4. 18application · medium

   A technician is preparing to power on a new MX7000 chassis for the first time. The technician has installed two power supplies, one management module in slot M1, and two compute sleds. The technician connects the power cords and presses the power button. The LCD remains dark and the chassis does not power on. What is the most likely cause?

   • AThe compute sleds are not compatible with the chassis.
   • BThe LCD is faulty and needs replacement.
   • CThe power supplies are not providing enough wattage.
   • DThe management module is not installed or is not seated correctly.
   Reveal Solution Discussion Select an answer first
5. 19expert · hard

   An MX7000 chassis is generating alerts that are not being delivered to the administrator's email. The administrator has configured the SMTP server settings in iDRAC and verified that the email address is correct. The administrator can access the iDRAC web interface remotely. What is the most likely cause of the email delivery failure?

   • AThe management module firmware is outdated.
   • BThe SMTP server is not reachable from the management module.
   • CThe alerts are not configured to be sent via email.
   • DThe LCD alert display is disabled.
   Reveal Solution Discussion Select an answer first
6. 20foundation · easy

   What is the purpose of an informational alert on the MX7000?

   • ATo notify of a normal operational event
   • BTo require immediate user action
   • CTo indicate a component failure
   • DTo warn of an impending failure
   Reveal Solution Discussion Select an answer first