Which cable type is typically used to connect a Dell PowerEdge server to a storage array over a Fibre Channel network?

Direct-attach copper (DAC) cable

Why is it important to label both ends of a network cable in a Dell PowerEdge server deployment?

To ensure the cable meets the required speed rating

To increase the signal strength of the connection

To prevent electromagnetic interference from other cables

To simplify troubleshooting and maintenance by identifying connections quickly

Which cable type is most appropriate for a 25GbE connection between two Dell PowerEdge servers in the same rack, less than 3 meters apart, where cost and power efficiency are priorities?

Direct-attach copper (DAC) cable

A technician is replacing a failed network cable in a Dell PowerEdge R650 server. The original cable was labeled 'Server-01-Data-10GbE-Port1'. The technician finds a similar unlabeled cable that appears to be the same type. What should the technician do before connecting the replacement cable?

Verify the cable is the correct type and length, then connect it and label it appropriately

Connect the unlabeled cable without labeling it to save time

Use any available cable in the rack, regardless of type or length

Connect the unlabeled cable and label it with the same label as the original

Dell PowerEdge Foundations v2

Domain 4Objective 2

Describe the Cables and Connections POWEREDGE-FOUNDATIONS-V2 Practice Questions (Page 1)

Part of the Server Networking and Connectivity domain, which accounts for 6% of the POWEREDGE-FOUNDATIONS-V2 exam.

17questions here

4free pages

4concepts

6%of the exam

Questions 1–5

1foundation · easy
Which cable type is typically used to connect a Dell PowerEdge server to a storage array over a Fibre Channel network?
Select an answer first
2foundation · easy
Why is it important to label both ends of a network cable in a Dell PowerEdge server deployment?
Select an answer first
3foundation · easy
Which cable type is most appropriate for a 25GbE connection between two Dell PowerEdge servers in the same rack, less than 3 meters apart, where cost and power efficiency are priorities?
Select an answer first
4application · medium
A technician is replacing a failed network cable in a Dell PowerEdge R650 server. The original cable was labeled 'Server-01-Data-10GbE-Port1'. The technician finds a similar unlabeled cable that appears to be the same type. What should the technician do before connecting the replacement cable?
Select an answer first
5foundation · easy
Which connector type is used for 40GbE and 100GbE Ethernet connections, often found on high-performance Dell PowerEdge servers and data center switches?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWEREDGE-FOUNDATIONS-V2

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWEREDGE-FOUNDATIONS-V2” is a trademark of its owner, used for identification only.