Which type of information is typically included in an LLDP advertisement?

Chassis ID, port ID, and system name

VLAN membership and trunk status

IP routing table and MAC address table

Spanning tree priority and port cost

How does a LAG typically distribute traffic across its member links?

It sends each packet to the link with the least current load

It uses a hashing algorithm based on frame fields such as MAC or IP addresses

It round-robins packets across all links

It sends all traffic over the first active link until it fails

A network administrator is configuring a LAG between two Dell switches. The switches support LACP. The administrator wants to ensure that the LAG is formed only if both switches agree on the configuration. Which LACP mode should be used?

Active mode on one switch and passive mode on the other.

What type of frames does STP use to exchange information between switches?

Address Resolution Protocol (ARP) packets

Dynamic Host Configuration Protocol (DHCP) messages

Bridge Protocol Data Units (BPDUs)

What is the primary purpose of the Link Layer Discovery Protocol (LLDP) in a network?

To advertise device information to directly connected neighbors

To prevent loops in a redundant Layer 2 network

To encrypt data transmitted between switches

To route packets between different IP subnets

Dell Networking Foundations

Domain 2Objective 2

Describe the Operation and Behavior of LLDP, VLANs, STP, and LAG NETWORKING-FOUNDATIONS Practice Questions (Page 2)

Part of the Ethernet Technologies domain, which accounts for 40% of the NETWORKING-FOUNDATIONS exam.

29questions here

6free pages

8concepts

40%of the exam

Questions 6–10

6foundation · easy
Which type of information is typically included in an LLDP advertisement?
Select an answer first
7foundation · easy
How does a LAG typically distribute traffic across its member links?
Select an answer first
8expert · hard
A network administrator is configuring a LAG between two Dell switches. The switches support LACP. The administrator wants to ensure that the LAG is formed only if both switches agree on the configuration. Which LACP mode should be used?
Select an answer first
9foundation · easy
What type of frames does STP use to exchange information between switches?
Select an answer first
10foundation · easy
What is the primary purpose of the Link Layer Discovery Protocol (LLDP) in a network?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to NETWORKING-FOUNDATIONS

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “NETWORKING-FOUNDATIONS” is a trademark of its owner, used for identification only.