Perform and Analyze System Health Check with Unisphere METRO-NODE-OPERATE Practice Questions (Page 5)

Questions 21–25

1. 21expert · hard

   A Metro Node system has been running with a warning on 'Backend Connectivity' for several days. The warning indicates that one of the two paths to a backend array is down. The administrator has verified that the cable and SFP are functional. The array's storage processor is also reporting no errors. What is the most likely next step to diagnose the issue?

   • ACheck the director's FC port configuration and the array's port settings for a mismatch.
   • BReboot the director to reset the FC port.
   • CReplace the backend array's storage processor.
   • DFail over all volumes to the peer director and continue operations.
   Reveal Solution Discussion Select an answer first
2. 22expert · hard

   A Metro Node system has two directors. The System Health check reports an error on Director 1: 'Internal Link Error'. The error message indicates that the internal PCIe link to a storage adapter has failed. The administrator has verified that the adapter is seated correctly. What is the most appropriate next step?

   • AReplace the storage adapter on Director 1.
   • BCheck the backend array's connectivity to ensure it is not the cause.
   • CReboot Director 1 to reset the PCIe link.
   • DFail over all I/O to Director 2 and continue operations.
   Reveal Solution Discussion Select an answer first
4. 23foundation · easy

   In Unisphere for Dell Metro Node, where would an administrator navigate to initiate the System Health check?

   • AUnder the 'Access' tab, select 'Hosts'
   • BUnder the 'Storage' tab, select 'Volumes'
   • CUnder the 'Settings' tab, select 'General'
   • DUnder the 'Monitor' tab, select 'System Health'
   Reveal Solution Discussion Select an answer first
5. 24foundation · easy

   When reviewing the System Health check results in Unisphere, what does a 'Warning' status typically indicate?

   • AThe health check could not be completed due to a connectivity issue
   • BA component has failed and requires immediate replacement
   • CA potential issue exists that may require attention, but the system is still operational
   • DThe system is operating normally with no action needed
   Reveal Solution Discussion Select an answer first
6. 25application · medium

   A System Health check on a Metro Node system shows a green checkmark for 'Software Version' but a red error for 'Director 1 - Power Supply 2'. What does this result indicate?

   • AThe entire Metro Node cluster is at risk of imminent failure.
   • BDirector 1 is completely powered off and not serving I/O.
   • CThe software version is incompatible with the power supply hardware.
   • DPower Supply 2 has failed, but Director 1 is still operational on the redundant power supply.
   Reveal Solution Discussion Select an answer first